Current kernels allow you to set the number of loop devices supported without recompiling the kernel. One of these methods is to add an options line to /etc/modules.conf. This method will only work if your loop support has been configured as a loadable kernel module (which is how most major Linux distributions come preconfigured now).

Edit /etc/modules.conf and add the following line.

options loop max_loop=64

After making the above change, simply reboot. Or you can try to use rmmod and insmod to make the change on the fly - but this will not work if you currently have any loop devices mounted (you'll get an error saying loop: Device or resource busy).

Continue with Section 3.4, “Creating the Loop Devices in /dev”.

Thanks to Paul A. Sand for pointing out the /etc/modules.conf option.

If your loop support has been compiled directly into the kernel (in other words, it is not loaded as a module), you can append the number of loop devices you would like to support at the linux boot prompt.

boot:  linux max_loop=64

Or, if you are using LILO, you can edit your linux boot stanza in /etc/lilo.conf and add/modify the append= line. Here is an example stanza showing append= (note: only add or modify the append line, don't change your whole stanza to look like this one or your system may not boot). For more information about LILO, consult the LILO mini-HOWTO at http://www.linuxdoc.org/HOWTO/mini/LILO.html.

image=/boot/vmlinuz
        label=linux
        root=/dev/hdb5
        initrd=/boot/initrd.img

	append=" max_loop=64"

        vga=788
        read-only

After changing /etc/lilo.conf, you need to run the lilo command for your changes to take effect.

bash# lilo


Added linux *
Added linux-nonfb
Added failsafe
Added windows
Added floppy

Next restart your system. After your system restarts, you can check your boot command line by typing the following:

bash# cat /proc/cmdline

Continue with Section 3.4, “Creating the Loop Devices in /dev”.

Thanks to Tony Melia for the boot prompt info.

If you have an older kernel (v. 2.2) or if you are completely comfortable recompiling the kernel, you can increase the number of loop devices supported by editing the /usr/src/linux/drivers/block/loop.c file.

Change the number in the following line to however many loop devices you'll need.

#define MAX_LOOP 16

Compile the new kernel or module as the case may be. If you need some help getting started with this, read /usr/src/linux/README or consult The Linux Kernel HOWTO.

Continue with Section 3.4, “Creating the Loop Devices in /dev”.

You should check how many /dev entries you have for loop devices.

bash# ls -l /dev/loop*

The mknod command creates the devices in the /dev directory. The loop devices have a major number of “7”, and the minor numbers begin at “0”. If your MAX_LOOP was defined as “8” in /usr/src/linux/drivers/block/loop.c, you should have /dev/loop0 through /dev/loop7. To create the /dev/loop8 device, use the following command (subsitute the appropriate number you need for both the “8's” in the example below).

bash# mknod -m660 /dev/loop8 b 7 8

Check Owner/Group & Permissions on the new file (using ls -l). You can change the owner and group with the following command:

bash# chown root.disk /dev/loop8

You can change the permissions using the following command:

bash# chmod 666 /dev/loop8